Rabbit L5-2.5L (CBUA) (2008)
Ride Height Sensor: Removal and Replacement
Vehicle Level Sensor
Vehicle Level Sensor (Rabbit)
Special tools, testers and auxiliary items required
^
Torque Wrench V.A.G 1331
Removing
-
Separate connector -1-.
-
Remove bolts -2- from lower transverse link.
-
Remove bolts -arrows- from the subframe.
-
Remove Left Rear Level Control System Sensor G76.
Installing
Installation is in reverse order of removal. Observe the following when doing so:
The Left Rear Level Control System Sensor G76 lever must point toward the outside of the vehicle.
-
After replacing, perform a headlamp basic setting Vehicle Diagnosis, Testing, and Information System VAS 5051 in "Guided Fault Finding"
function
Tightening Specifications
Vehicle Level Sensor (Aluminum Subframe)
Vehicle Level Sensor (Rabbit, Aluminum Subframe)
Special tools, testers and auxiliary items required
^
Torque Wrench V.A.G 1331
Removing