Rabbit L5-2.5L (CBUA) (2008)
1 - Bolt
^
50 Nm plus an additional 45° turn
^
Always replace after removal
2 - Mounting bracket
3 - Bolt
^
M12 x 1.5 x 80
^
90 Nm plus an additional 90° turn
^
Always replace after removal
4 - Coupling rod
^
Coupling rod changed in model year 2004
During start of production, coupling rods with two ball joints were revised to coupling rods with one ball joint and a bonded rubber bushing. The side
with the bonded rubber bushing is attached to the stabilizer bar.
A mixed installation is not permitted
^
Connects the stabilizer bar to longitudinal control arm/wheel bearing housing
5 - Bolt
^
90 Nm plus an additional 90° turn
^
Observe tightening sequence
^
Always replace after removal
6 - Trailing link
7 - Bolt
^
8 Nm
8 - Right Rear ABS Wheel Speed Sensor G44 / Left Rear ABS Wheel Speed Sensor G46
^
Can be checked in Guided Fault Finding using the
^
Before inserting sensor, clean inner surface of mounting hole and coat with Polycarbamide grease G 000 650
9 - Wheel Bearing Housing
10 - Bonded rubber bushing
11 - Nut
^
40 Nm
^
Always replace after removal