Rabbit L5-2.5L (CBUA) (2008)
-
Tighten bolts -arrows- on old impressions.
-
Lower suspension back using engine/transmission jack V.A.G 1383 A and remove wheel hub support T10149 from wheel hub.
-
Tighten bolts -2- for trailing link to tightening torque, make sure components are in the required position when doing this.
-
Connect coupling rod -1- to the wheel bearing housing and stabilizer bar.
-
Install parking brake cable -1- on trailing link -2- -arrow-.
-
Install coil spring.
-
Install wheel and tighten.
-
Perform vehicle alignment.
Tightening Specifications