Rabbit L5-2.5L (CBUA) (2008)
Fluid Pan: Service and Repair
Automatic Transmission Fluid Pan - 09G, 6 Speed A/T FWD
Special tools, testers and auxiliary items required
^
Drip tray V.A.G 1306
^
Torque Wrench V.A.G 1783
Removing
-
Remove noise insulation below engine.
-
Place drip tray V.A.G 1306 underneath.
-
Remove ATF inspection plug -A-.
-
Remove overflow tube -C- and allow remaining ATF to drain.
-
Remove bolts from oil pan -arrows- in diagonal sequence.
-
Remove oil pan together with seal.
Installing
Installation is in reverse order of removal. Pay attention to the following:
-
Clean two magnets in oil pan recesses. Ensure that the magnets are in full contact with the oil pan.
-
Check seal for damage and make sure all of the spacers (quantity: 8) are present.
Otherwise, replace the seal.
-
Install oil pan and seal; when doing this be sure not to pinch any lines.
-
Make sure oil pan seal is properly seated.