Rabbit L5-2.5L (CBUA) (2008)
Transmission Position Switch/Sensor: Service and Repair
Multi-Function Transmission Range Switch, Installing
Multi-Function Transmission Range Switch, Installing - 09G, 6 Speed A/T FWD
Special tools, testers and auxiliary items required
^
Torque Wrench V.A.G 1331
Installation is in reverse order of removal. Pay attention to the following:
-
Connect multi-function switch -4- to shift rod -6-.
-
Hand-tighten securing bolts -5- for multi-function switch.
-
Bend hooks of locking washer -2- back.
-
Install washers -2- and -3- onto shift rod -6-.
-
Attach washer -2- with hooks facing upward.
-
Insert washer -2- with long and thin guides into long and narrow depressions in shift rod -6-.
-
Tighten nut -1- to 7 Nm.
-
Secure nut -1- by bending hooks of locking washer upward -2-.
-
Replace locking washer if hooks are broken off.
-
Attach lever -3- onto shift rod -4-.
-
Shift transmission to position "P" using lever -3-, i.e. push lever -3- rearward against direction of travel until stop.
-
Shift transmission to position "N" using lever -3-. To do so, press lever -3- two latched positions toward front in direction of travel.
-
Install spring washer -2- and nut -1- on shift rod -4-.
-
Tighten nut -1- to 13 Nm.