Rabbit L5-2.5L (CBUA) (2008)
/Page-863002.png)
-
Remove drive plate again and use shim - 2 -. Tighten bolts - 3 - to 30 Nm again and repeat measurement.
If specified value is OK:
-
Tighten bolts to 60 Nm and turn an additional 90° (1/4 rotation, additional rotation may occur in several stages).
The rest of installation follows the reverse of the removal procedures. When doing this note the following:
^
Remove locking pin T40069 from cylinder block at rear and screw in plug (30 Nm).
