Rabbit L5-2.5L (CBUA) (2008)
-
Pry out sealing ring using screwdriver -A-, while doing this support screwdriver at assembly tool 3253/2.
Note:
^
Do not damage sleeve, otherwise leaks will occur.
^
If damaged, replace sleeve
Installing
-
Drive new seal in as far as stop; be sure not to distort seal.
-
Fill area between sealing lip and dust lip halfway with sealing grease G 052 128 A1.
-
Insert flange shaft.
-
Secure flange shaft with countersunk bolt.
-
If you have removed turbocharger oil return line at engine, re-install it now -arrow-.
-
Install drive axle -1- to flange shaft.
-
If equipped, install drive axle shield.
-
Check and fill gear oil.
-
Install noise insulation.
Tightening torque
Flange shaft to transmission (countersunk screw) 25 Nm