Rabbit L5-2.5L (CBUA) (2008)
-
Remove bolts for flange shaft, by screwing two bolts into the flange and counter-holding flange shaft using a pry bar.
-
Pull out flange shaft with spring.
-
Pry out sealing ring using screwdriver -A-, while doing this support screwdriver at assembly tool 3253/2.
Note:
^
Do not damage sleeve, otherwise leaks will occur.
^
If damaged, replace sleeve.
Installing
-
Drive new seal in as far as the stop; be sure not to distort seal.
-
Fill area between sealing lip and dust lip halfway with sealing grease G 052 128 A1.
-
Insert flange shaft.