Rabbit L5-2.5L (CBUA) (2008)
Windshield Washer Pump: Service and Repair
Windshield And Rear Window Washer Pump
NOTE: Depending on equipment, location of Windshield and Rear Window Washer Pump V59 may differ slightly from illustrations. Removal is
performed in the same way.
Removing
-
Switch off ignition, switch off all electrical consumers and remove ignition key.
-
Remove front bumper cover.
NOTE: In order to prevent interchanging washer fluid line connections at Windshield and Rear Window Washer Pump V59, connections at pump
and hose lines are color-coded. Hose connector pieces must be connected to the corresponding colored pump connections during installation.
-
To release, twist securing clips at hose connections - 3 - and - 5 - and disconnect them from Windshield and Rear Window Washer Pump V59 - 4
-.
-
If necessary, collect the draining fluid in a suitable container.
-
Remove Windshield and Rear Window Washer Pump V59 - 4 - upward out of reservoir.
-
Disconnect electrical connection - 2 -.
Installing
Install in reverse order of removal, noting the following:
-
Tighten all threaded connections to specified torques.
-
Bleed headlamp washer system after completing assembly work.