Scirocco L4-1781cc 1.8L SOHC (1987)
Clutch Housing: Service and Repair
1
Oil drain plug
-
Torque 25 Nm (18 ft lb)
2
Dowel sleeve
-
Qty: 2
3
Shim S2
-
Always 1 mm (0.04 in) thick
4
Outer race of tapered roller bearing for differential
-
Removing/Installing - See: Front Final Drive/Final Drive Gear
-
When replaced, differential must be adjusted
5
Magnet
-
Retained in housing joint surface
-
Install with AMV 188 200 03 sealant
6
Shim S3
7
Outer race for output shaft tapered roller bearing
-
Removing/Installing - See: Output Shaft
-
When replacing: adjust output shaft
8
Needle bearing
-
Removal of needle bearing for input shaft
^
A = Internal extractor 18.5-23.5 mm, e.g. Kukko 21/3
^
B = Counter support, e.g. Kukko 22/1