Tiguan 4Motion (5N1) L4-2.0L Turbo (CCTA) (2009)
/l4-2.0l_turbo_(ccta)/Page-1754002.png)
-
The remainder - 3 - stays between the roof - 4 - and the assembly frame - 2 -.
-
Remove any left over adhesive using Adhesive Remover (VAS 6349).
-
The adhesion surface on the roof cutout must be free of dust and grease.
-
Clean adhesion surface thoroughly using Cleaning Solution (D 009 401 04).
-
Wipe the adhesive surface on the roof cutout using the primer towel supplied.
-
Always pay attention to the drying time for the primer towel supplied.
-
Center the new outer seal - 1 - so that the joint - arrow - at at the center of the rear roof opening.
