Tiguan 4Motion (5N1) L4-2.0L Turbo (CCTA) (2009)
Replacing the side seal
-
Remove the side seal - 2 - from the rear glass sunroof panel profile - 1 -.
‹› The seal is supplied with excess length. Cut the new seal to the necessary length. It is recommended to leave the seal 1 - 2 mm longer than
necessary so that it can be stretched during installation.
-
Remove any left over adhesive using Adhesive Remover (VAS 6349).
-
The adhesion surface on the rear glass sunroof panel must be free of dust and grease.
-
Clean adhesion surface thoroughly using Cleaning Solution (D 009 401 04).
-
Wipe the adhesive surface on the rear glass sunroof panel using the primer towel supplied.
‹› Always pay attention to the drying time for the primer towel supplied.
-
Remove the protective foil from the adhesive tape on the new seal.
-
Attach the new seal - 2 - with the retainer - 1 - to the glass sunroof panel - 3 -.