Tiguan 4Motion (5N1) L4-2.0L Turbo (CCTA) (2009)
-
Remove the cable channel from the console.
-
Press the red securing clip down in direction of - arrow -.
-
Release and remove connector from control module in direction of - arrow -.
-
Insert (V.A.G 1869/2).
-
Attach bleeder hose of bleeder bottles to left front and left rear brake caliper bleeder valves and open bleeder valves.
-
Operate brake pedal using (V.A.G 1869/2) at least 60 mm.
-
Close left front and left rear bleeder valves.
-
Do not remove (V.A.G 1869/2).
-
Place sufficient lint-free cloths under the control module and hydraulic unit.
Make sure that brake fluid does not come in contact with the terminals.
-
First mark both brake lines from the brake master cylinder and remove them.
-
Plug the brake lines and threaded holes immediately with sealing plugs from the repair kit Part No. 1H0 698 311 A.
-
Mark, unfasten and plug the remaining brake lines (brake calipers).
-
Lift the hydraulic unit with control module up and out of the dampers - arrow -.