Tiguan 4Motion (5N1) L4-2.0L Turbo (CCTA) (2009)
Rear Side Airbag Crash Sensor, Driver Side
‹› The driver side rear side airbag crash sensor (G256 ) is installed on the driver side in front of the rear wheel housing.
Removing
CAUTION!
Observe safety precautions for working on airbags => [ Airbag Safety Precautions ] See: Service Precautions/Airbag Safety Precautions
-
Disconnect vehicle battery.
-
Move the left rear bench seat as far forward as possible.
-
Remove the rear wheel housing trim:
‹› without rear side airbags
‹› with rear side airbags
-
Press the connector lock and remove the connector - 1 - from the crash sensor - 3 -.
-
Remove bolt - 2 - (6 Nm).
Installing
-
Installation is performed in the reverse order of removal.
-
Switch on ignition.
CAUTION!
Make sure that no one is in the vehicle.
-
Connect vehicle battery.
Rear Side Airbag Crash Sensor, Passenger Side
Rear Side Airbag Crash Sensor, Passenger Side