Tiguan 4Motion (5N1) L4-2.0L Turbo (CCTA) (2009)
-
Remove bolt - 1 - (40 Nm) and remove belt relay - 2 - from belt height adjuster.
-
Remove screw - 1 - (40 Nm) and remove automatic belt retractors - 2 - from B-pillar.
CAUTION!
Electrostatic charges may result in involuntary deployment of the belt tensioner. Therefore the technician must discharge static electricity
from the body before separating the ignition and ground wiring. This is done e.g. by briefly touching the body or the door striker or pin.
-
Disconnect wiring harness from belt inertia reels.
Installing
-
Installation is performed in the reverse order of removal.
-
Connect vehicle battery.