Tiguan 4Motion (5N1) L4-2.0L Turbo (CCTA) (2009)
Seat Occupant Sensor: Service and Repair
Front Passenger Seat Occupied Sensor
Front Passenger Seat Occupied Sensor
CAUTION!
If Front Passenger's Seat Occupied Sensor ( G128) is replaced, also the upholstery, front seat cushion must always be replaced!
Removing
-
Mount the fixture for seat repair (VAS 6136 ) on the engine and transmission holder (VAS 6095 ).
-
Remove front seat => [ Front Seat ] See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seat
-
Attach the seat to the fixture for seat repair ( VAS 6136).
-
Remove the front safety belt latch => [ Front Seat Belt Latch ] See: Seat Belt Systems/Seat Belt Latch/Service and Repair/Front Seat Belt Latch
-
Remove the trim on the tunnel side => [ Tunnel Side Trim ] See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Tunnel
Side Trim
-
Remove the drawer mount, if equipped => [ Seat Drawer Mount ] See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Seat
Drawer Mount
Passenger Seat without Height Adjustment
-
Remove the backrest adjustment wheel => [ Backrest Adjusting Wheel ] See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Backrest Adjusting Wheel
-
Remove the trim on the door sill side => [ Front Sill Panel Trim ] See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and
Repair/Front Sill Panel Trim
Passenger Seat with Pass-Through
-
Remove the trim on the door sill side
-
Remove the bracket, trim, door sill side => [ Front Door Trim ] See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door
Panel/Service and Repair/Front Door Trim
Front Seats with manual height adjustment
-
Remove the backrest adjustment wheel => [ Backrest Adjusting Wheel ] See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Backrest Adjusting Wheel
-
Remove the trim on the door sill side => [ Front Sill Panel Trim ] See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and
Repair/Front Sill Panel Trim
-
Remove the bracket, trim, door sill side.
Electric Driver Seat
-
Remove the trim on the door sill side => [ Front Sill Panel Trim ] See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and
Repair/Front Sill Panel Trim
-
Remove the bracket, trim, door sill side.
-
Disconnect the two harness connectors for the backrest drives underneath the seat frame. Remove the harness connectors from the seat frame.
all seats
-
Cut the mesh hose cable tie and pull the harness connector belt lock through it.
‹› On vehicles with a luggage pass-through, it is sufficient to fold the backrest forward, it does not have to be removed.
-
Remove backrest => [ Backrest ] See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Backrest