Tiguan 4Motion (5N1) L4-2.0L Turbo (CCTA) (2009)
/l4-2.0l_turbo_(ccta)/Page-1200014.png)
-
Secure spring clamp on bellows using (V.A.G 1275).
-
Slightly grease the sealing surface of the bellow to the steering gear housing with grease (G 052 168 A1) (from the repair kit, from Fuchs Renolit
JP1619).
-
Push the boot all the way onto the steering gear housing.
-
Tighten new clamp using (VAS 6199) to the extent depicted in the illustration.
Further installation is in the reverse sequence to removal.
After the installation the vehicle must be measured.
-
Perform vehicle alignment. Refer to => [ Wheel Alignment ] See: Alignment/Service and Repair/Wheel Alignment.
-
The boots have been exchanged, then perform a basic setting for the steering angle sensor (G85) via the Guided Fault Finding function using (VAS
5051B).
-
Then perform basic setting of steering system via the Guided Fault Finding function using (VAS 5051B).
Tightening Specifications
Steering Gear Assembly Overview
Steering Gear Assembly Overview
