Tiguan 4Motion (5N1) L4-2.0L Turbo (CCTA) (2009)
‹› Tightening order => [ Transmission side sealing flange, tightening sequence ]
5
Intermediate plate
‹› must be located on dowel sleeves
‹› do not damage or bend when doing assembly work
‹› Is hooked in at sealing flange => [ Installing intermediate plate ]
6
Bolt
‹› for dual-mass flywheel/drive plate
‹› 60 Nm + 90° (1/4 turn) additional turn
‹› Replace
7
Dual-mass flywheel/drive plate
‹› Dual-mass flywheel, removing and installing => [ Dual Mass Flywheel, Removing and Installing ] See: Flywheel/Service and Repair/Dual
Mass Flywheel, Removing and Installing
‹› Drive plate, removing and installing => [ Drive Plate, Removing and Installing ] See: Drive Plate, Removing and Installing
‹› Only possible to install in one position - Bores are offset
8
Fitting pin
‹› not installed
Transmission side sealing flange, tightening sequence
-
Tighten the bolts - 1 through 8 - in the sequence shown:
-
1. Hand tighten the bolts
-
2. Tighten the bolts to 9 Nm
Installing intermediate plate