Tiguan 4Motion (5N1) L4-2.0L Turbo (CCTA) (2009)
^
Disconnect the plug (arrow).
^
Connect the new wiring harness with the original harness connector on the vehicle and tape connection to secure.
^
Raise and support the vehicle.
^
Disconnect the harness connector on the Haldex module.
^
Install new Haldex Control Module Part No. 0AY598554A OR 0AY598554B, see repair Manual Group 39 Rear Final Drive, Differential in
ElsaWeb.
^
Release the harness retainer (arrow).
^
Carefully pull out the original Haldex wiring harness, while pulling though new harness.
^
Remove the adhesive tape.
^
Secure the harness retainer of the new wiring loom from above into the access hole.
^
Connect the remaining harness connector to the Haldex module.