Touareg V10-5.0L DSL Turbo (BWF) (2006)
Cruise Control Module: Service and Repair
Distance Regulation Control Module J428, Removing And Installing
Distance Regulation Control Module J428 is mounted on front of vehicle, behind VW-logo in the radiator protective grille.
Distance Regulation Control Module J428 must not be disassembled further and contains the following components:
-
Adaptive Cruise Control Sensor G550
-
Distance Regulation Sensor Heater Z47
Removing:
-
Switch off ignition, switch off all electrical consumers and remove ignition key.
-
Remove radiator grille.
-
0Unclip Distance Regulation Control Module J428 -1 - from the three mounts - 2 -.
-
Swivel Distance Regulation Control Module J428 -1 -forward, paying attention to lengths of connected wires.
-
Disengage and disconnect harness connector - 2 - and remove Distance Regulation Control Module J428 from vehicle.
Installing:
Install in reverse order of removal, noting the following:
Adaptive Cruise Control Sensor G550 in Distance Regulation Control Module J428 is to be calibrated after:
-
every removal and installation of Adaptive Cruise Control Sensor G550,
-
every removal and installation, and replacement of assembly carrier,
-
if there is a suspicion of forceful impact on these two parts, an accident during driving or similar.
-
When first commissioning or replacing Distance Regulation Control Module J428, initialize ADR.