Touareg V8-4.2L (AXQ) (2006)
‹› Do not use metallic tools to pry off relays from relay carrier. The terminals could conduct electricity.
-
Bridge terminals 6d + 6e on relay carrier using appropriate adapter cables.
-
Switch ignition on.
Transfer Fuel Pump (FP) (G23), left, must start up.
-
Switch ignition off.
If Fuel Pump (FP) runs:
-
Check activation of Fuel Pump (FP) 2 Relay (J49), left, - 2 - according to wiring diagram:
-
Erase DTC memory of Engine Control Module (ECM) , Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code.
If Fuel Pump (FP) does not run:
-
Remove bridge from terminal 6e.
-
Connect multimeter to terminal 6e + Ground (GND) of relay socket for voltage measurement.
-
Switch ignition on.
Specified value: at least 11.5 V
-
Switch ignition off.