Touareg V8-4.2L (BAR) (2007)
Air Duct: Service and Repair
Intake Housing
Removing
-
Remove the plenum chamber cover "Flush Bonded Windows".
-
Remove Engine Control Module (ECM).
-
Loosen ECM bracket to reach nuts - 1 -.
-
Remove nuts - 1 - and remove cover grille - A - from air intake shroud.
-
Reach into intake housing from above and loosen retaining clamps - 1 -.
-
Remove intake housing from plenum chamber.
Installing
Installation is carried out in the reverse order, when doing this note the following:
-
Check for possible contamination on water drain valve - arrow - before installation. Clean water drain valve if necessary.