Touareg V8-4.2L (BAR) (2007)
High Pressure Sensor / Switch: Service and Repair
High Pressure Sensor
Removing
-
Remove air intake shroud. Refer to --> [ Intake Housing ] See: Air Duct/Service and Repair.
-
Separator connectors.
-
Remove High Pressure Sensor (G65) - 1 - from coolant line in plenum chamber.
‹› Counterhold the threaded connection with a suitable tool when loosening and tightening.
Installing
Installation is carried out in the reverse order, when doing this note the following:
-
Replace O-ring.
High Pressure Sensor (G65) torque is 8 ± 1 Nm.
‹› Counterhold the threaded connection with a suitable tool when loosening and tightening.