Touareg 2 V6-3.6L (BHK) (2008)
/Page-548002.png)
‹› Installed in the exhaust gas stream of cylinders 1, 2 and 3.
7
Nut
‹› M10: 40 Nm.
‹› Replace.
8
Suspended mount
9
Transmission carrier
‹› Must be removed to remove catalytic converters --> [ (Item 11) Catalytic converters ]. Refer to --> [ Catalytic Converter ] See: Catalytic
Converter/Service and Repair/Catalytic Converter.
10
25 Nm
11
Catalytic converters
12
Double pipe clamp
13
Bolt, 25 Nm
‹› For support front catalytic converters at engine/transmission bracket.
14
Oxygen sensor behind three way catalytic converter (G130), 50 Nm
‹› Installed in the exhaust gas stream of cylinders 1, 2 and 3.
‹› Grease thread only using (G 052 112 A3); do not let (G 052 112 A3) get onto slits of oxygen sensor body.
‹› Use ring spanner set for oxygen sensor (3337) for removal and installation.
15
Heated oxygen sensor (G39), 50 Nm
‹› Installed in the exhaust gas stream of cylinders 1, 2 and 3.
‹› Grease thread only using (G 052 112 A3); do not let (G 052 112 A3) get onto slits of oxygen sensor body.
‹› Use ring spanner set for oxygen sensor (3337) for removal and installation.
16
Heated Oxygen Sensor (HO2S) 2 (G108), 50 Nm
‹› Installed in the exhaust gas stream of cylinders 4, 5 and 6.
‹› Grease thread only using (G 052 112 A3); do not let (G 052 112 A3) get onto slits of oxygen sensor body.
‹› Use ring spanner set for oxygen sensor (3337) for removal and installation.
17
Oxygen Sensor (O2S) 2 behind Three Way Catalytic Converter (TWC) (G131), 50 Nm
‹› Installed in the exhaust gas stream of cylinders 4, 5 and 6.
‹› Grease thread only using (G 052 112 A3); do not let (G 052 112 A3) get onto slits of oxygen sensor body.
‹› Use ring spanner set for oxygen sensor (3337) for removal and installation.
18
Primary catalytic converter
‹› Installed in the exhaust gas stream of cylinders 4, 5 and 6.
19
Bracket
20
Intake manifold support
