Touareg 2 V6-3.6L (BHK) (2008)
Start diagnosis
Function test
-
Connect scan tool.
-
Start the engine and let it run at idle.
-
Select "Diagnostic mode 6: Check test results of components that are not continuously monitored".
-
Select "Test-ID 01: Oxygen sensor monitoring before catalytic converter".
-
Select "Test-ID 131: Dynamic test".
-
Check the specified values at idle.
If the specified values are obtained:
-
End diagnosis and switch ignition off.
If the specified values are not obtained:
Start diagnosis
-
Disconnect the Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) (G130) electrical harness connector - 1 -.
Checking primary voltage
-
Switch the ignition on.
-
Using a multimeter, check the Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) (G130) electrical harness connector
terminals 3 to 4 for voltage.