Touareg 2 V6-3.6L (BHK) (2008)
Headlamp Control Module: Service and Repair
Hid Headlamp Control Module
HID Headlamps with Cornering Lamp, through 11.06
HID Headlamp Control Module
‹› Left High-intensity Gas Discharge Lamp Control Module (J343) and Right High-intensity Gas Discharge Lamp Control Module (J344) is not
capable of On Board Diagnostic (OBD).
‹› Illustrations depict replacement of High-intensity Gas Discharge Lamp Control Module at left headlamp.
‹› Replacement of Left High-intensity Gas Discharge Lamp Control Module (J343) and of Right High-intensity Gas Discharge Lamp Control
Module (J344) is performed analogously.
Removing
-
Switch off ignition, switch off all electrical consumers and remove ignition key.
-
Remove headlamp --> [ Headlamps, through 11.06 ] .
-
Remove mounting bolts - arrows - and pull off bracket - 1 - with HID lamp control module - 2 - as far as wire lengths allow from headlamp.
‹› High-intensity Gas Discharge Lamp Control Module - 2 - is not yet removed from bracket - 1 - to obtain better access to the harness connectors.
-
Disengage retaining tab - arrow A - of harness connector - 1 - and disconnect harness connector - 1 -.
-
Release retainer - 3 - on connector - 2 - in - direction of arrow B - and remove connector - 2 -.