Touareg 2 V6-3.6L (BHK) (2008)
-
Remove bolts - arrows - for subframe.
-
Lower scissor lift table slightly and disconnect ventilation line from final drive connecting nipple.
-
Slowly lower subframe.
Installing
Installation is the reverse of removal, with special attention to the following:
-
Tighten subframe using the old bolts. They have to be replaced with new bolts following wheel alignment.
-
Tighten old bolts to specifications without additional tightening, while doing so.
-
After installation, a vehicle alignment must be performed. Refer to --> [ Wheel Alignment ] See: Alignment/Service and Repair/Wheel Alignment.
-
Adjust parking brake.
With Separable Stabilizer Bar
-
Bleed separable stabilizer bar. Refer to --> [ Separable Stabilizer Bar, Bleeding ] See: Stabilizer Bar/Service and Repair/Procedures.
Continuation for All
-
Bleed brake system.
-
Install wheels and tires.
Tightening Specifications