Touareg 2 V6-3.6L (BHK) (2008)
‹› Always replace after removal.
4
Mount
5
Seal
‹› Always replace.
6
Residual pressure retaining valve, 10 Nm
CAUTION!
‹› Observe important notes about removal and installation
‹› If residual pressure retaining valve sticks, the vehicle must be on a hoist and the wheels must rotate freely in order to replace the valve.
‹› When removing air line, there is the possibility that the residual pressure retaining valve will also be removed.
‹› If vehicle is not raised with a hoist, vehicle sinks immediately on side where residual pressure retaining valve was removed. There is a strong
risk of injury because the arms are clamped.
‹› Vehicle must remain on hoist until a new residual pressure retaining valve is installed and air spring damper is refilled.
7
Air spring
‹› Follow repair notes for servicing air spring dampers, refer to --> [ Air Spring Damper Repair Information ] See: Procedures/Front
Suspension/Air Spring Damper Repair Information.
‹› When the vehicle has been driven 200,000 km, if there is damage to an air spring, it is recommended that the opposite air spring is also
replaced.
8
Buffer stop
9
Shock absorber
‹› Follow repair notes for servicing air spring dampers, refer to --> [ Air Spring Damper Repair Information ] See: Procedures/Front
Suspension/Air Spring Damper Repair Information.
10
Seal
‹› Always replace.
‹› Grease with (N 052 150 00).
11
Boot
‹› Always replace.
12
Clamp
‹› Always replace.
Air Spring Damper Components
Air Spring Damper Components
‹› The --> [ (Item 2) Cover ] , --> [ (Item 3) Outer guide ] , --> [ (Item 4) Boot ] , and --> [ (Item 5) Rolling piston ] are components of the air
spring damper. They are installed together and cannot be disassembled.