Dimensions of lettering on rear lid
| Dimensions of lettering on rear lid |
Note| t | The height and side dimensions of lettering for the different engines is identical. |
| t | When fitting the lettering, observe the fitting notes below. |
| Fitting notes |
| t | Heat lettering or emblem with hot air blower -V.A.G 1416- before removing. |
| t | If the lettering or emblem is removed and reinstalled, only use adhesive remover -D 002 000 10- to remove the adhesive remains. |
| t | Remove existing adhesive residue of adhesive tape using adhesive strip remover -VAS 6349-. |
| t | Ensure that the adhesive surfaces are free of dust and grease. |
| t | The lettering or emblem must be bonded in place immediately after cleaning. |
| t | Remove protective backing immediately before installation. |
| t | Working temperature is approx. 21°C. |
| t | Lettering or emblem cannot be removed without becoming damaged. |
| 1 - | Lettering |
| q | Model designation. |
| 2 - | Lettering |
| q | Engine designation. |
| 3 - | Side dimension |
| q | 20 mm from outer edge of rear lid to lettering. |
| 4 - | Rear lid |
| 5 - | Tail light |
| 6 - | Height dimension |
| q | 102 mm from bottom edge of rear lid to lettering |
| 7 - | Height dimension |
| q | 108 mm from bottom edge of rear lid to lettering |
| 8 - | Side dimension |
| q | 20 mm from outer edge of rear lid to lettering. |
