Volkswagen Workshop Service and Repair Manuals > Up! > Body | General body repairs, interior | Interior equipment | Storage compartments/covers | Removing and installing handbrake lever boot

Removing and installing handbrake lever boot

Special tools and workshop equipment required

t	Torque wrench -V.A.G 1783-

Note

To enable the procedure to be illustrated more clearly, the front seats are not shown in the following figures.

Removing

–	Switch off ignition.

–	Position handbrake lever in uppermost position.

–	Remove cover cap -1- and unscrew bolt -2- (1.5 Nm).

–	Raise cover for handbrake lever -3- at rear and remove forwards over handbrake lever.

Installing

Note

Before installing, check all fasteners for damage and renew if necessary.

–	Position handbrake lever in uppermost position.

–	Secure cover for handbrake lever in bodywork.

–	Further installation is performed in the reverse order of removal.

Volkswagen Workshop Service and Repair Manuals