–
| Pull out connector mechanism -1- carefully with small screwdriver -arrow- and unplug electrical connector -2-. |
–
| Unscrew two bolts -3- and -4- in each case. |
–
| Remove front passenger side airbag downwards. |
WARNING Set down airbag with impact cushion facing upwards. |
|
WARNING t
| Follow safety regulations for pyrotechnic components → Chapter. |
t
| Before handling pyrotechnic components (e.g. connecting the electrical connector), the person handling them must ensure that he/she is „electrically discharged“. To do this e.g. briefly touch the door striker plate. |
|
Install in reverse order, but note the following: |
Note t
| Ensure electrical connector is pushed fully onto stop and engages audibly. |
t
| Ensure that no cables are trapped. |
–
| Fit new dash panel after airbag has been triggered → Chapter. |
WARNING Battery must be connected with ignition switched on. If pyrotechnic components (e.g. airbag, seat belt tensioners) are repaired incorrectly, undesired triggering may occur after the battery is connected. Ensure that nobody is in vehicle when connecting battery. |
|
Note If the airbag warning lamp -K75- indicates a fault following installation, the event memory must be read, cleared and then read again → Vehicle diagnostic tester. |
Installation tips: for example tightening torques, renewing components → Chapter. |
|
|
|