volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Releasing and securing B-pillar trim, 2-door models > < Removing and installing B-pillar trim, 2-door models

Up!

Releasing and securing B-pillar trim, 4-door models
Releasing and securing B-pillar trim, 4-door models
Special tools and workshop equipment required
   
t  Removing wedge -3409-
  Note
Releasing and securing of B-pillar trim are described for the left side of the vehicle. Releasing and securing on the right side is similar.
Releasing
  W00-0016
–  Release upper B-pillar trim -3- from door seal beading.
–  Release retaining clip -1- of B-pillar trim -3- using removing wedge -3409- in lower area from bodywork mountings in -direction of arrow-.
–  Release retaining clip -2- of B-pillar trim -3- using removing wedge -3409- in upper area from bodywork mountings in -direction of arrow-.

Securing
  Note
t  Before installing, check all fasteners for damage and renew if necessary.
t  When installing, the belt adjuster slide and the button of the trim must be in the same position.
t  After installation, make sure that B-pillar trim -3- is behind beading of door seal.
–  Install in reverse order of removal.
   

Releasing and securing B-pillar trim, 2-door models > < Removing and installing B-pillar trim, 2-door models