Up!
Note
|
Removing |
– | Remove dash panel → Chapter. |
– | Remove dash panel central tube → Chapter. |
– | Remove heater → Heating, air-conditioning system; Rep. gr.87. |
– | Remove accelerator module → Fuel supply; Rep. gr.20. |
– | Release clip nuts -2-. |
– | Pull inner bulkhead insulation -1- off studs. |
Installing |
Note
t | Carry out a visual inspection to confirm correct installation location. |
t | Before installing, check all fasteners for damage and renew if necessary. |
Install in reverse order of removal. When doing this, observe the following: |
– | Position bulkhead insulation -1- on studs. |