volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing steering angle sender > < Assembly overview - speed sensor on rear axle

Up!

Removing and installing speed sensor on rear axle
Removing and installing speed sensor on rear axle
Removing:
–  Raise vehicle.
   
–  Separate connector -1- from speed sensor wire and from speed sensor.
–  Remove bolt -2- from stub axle.
–  Pull ABS speed sensor out of stub axle.
Installing:
–  Before inserting speed sensor, clean hole inner surface and coat speed sensor all-round with high-temperature paste G 052 112 A3.
–  Insert speed sensor into hole in stub axle and tighten bolt to 8 Nm.
–  Connect speed sensor to speed sensor wire.
  N45-0117

Removing and installing steering angle sender > < Assembly overview - speed sensor on rear axle