volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing brake master cylinder > < Assembly overview - brake servo/brake master cylinder

Up!

Removing and installing brake light switch
Removing and installing brake light switch
Removing:
–  Remove air filter housing → 3 cyl. injection engine, toothed belt drive (4 valves); Rep. gr.24.
Only for vehicles with air conditioning system:
   
–  Disconnect connector -2- from high-pressure sender -G65--1-.
Continuation for all models:
–  Disconnect connector -A- from brake fluid level warning contact -F34-.
  N87-10887
–  Disconnect connector -B- from brake light switch -F-.
  N47-10233
–  Lay connectors together with wiring harness to side.
–  Unscrew bolt -1 arrow- from brake master cylinder.
–  Pull brake light switch -F--2- off brake master cylinder.
Installing:
–  Install in reverse order.
  N47-10234
Specified torque: 
Torx bolt to brake master cylinder7 Nm

   

Removing and installing brake master cylinder > < Assembly overview - brake servo/brake master cylinder