Volkswagen Workshop Service and Repair Manuals > Up! > Heating, ventilation, air conditioning system | Heating, air conditioning | Air conditioner | Heater and air conditioning unit, front | Removing and installing flexible shaft for temperature flap

Removing and installing flexible shaft for temperature flap

Removing

–	Remove dash panel end trim on driver side → General body repairs, interior; Rep. gr.68.

–	Remove control and display unit → Chapter.

Move flexible shaft to following position:

l	Turn rotary knob for temperature regulation -4- until catch -arrow A- of flexible shaft -2- is visible on temperature flap actuator -1-.

–	Release catch -arrow A- of flexible shaft -2- using a small screwdriver and pull out shaft from temperature flap actuator -1-.

–	Release catch -arrow B- of flexible shaft -3- and remove shaft from control and display unit -3-.

Installing

–	Install in reverse order.

Checking function

–	Check whether temperature knob can be easily turned from „Cold“ to „Warm“.

Volkswagen Workshop Service and Repair Manuals