Up!
| Assembly overview - sump / oil pump |
| 1 - | Oil dipstick |
| q | The oil level must not be above the max. mark! |
| q | Markings → Fig.. |
| 2 - | Camshaft housing |
| 3 - | Cap |
| q | Renew seal if damaged. |
| 4 - | Non-return valve |
| 5 - | Seal |
| q | Renew if damaged. |
| 6 - | Oil separator |
| q | To remove, intake manifold must be removed → Chapter. |
| q | Install with sealant D 176 501 A1 |
| 7 - | 9 Nm |
| 8 - | 0.3 … 0.6 bar oil pressure switch -F1-. |
| q | Specified torque: 20 Nm |
| q | Checking oil pressure switch → Chapter. |
| 9 - | Connector |
| 10 - | Oil filter |
| q | Observe installation instructions on oil filter. |
| q | Remove and install with oil filter tool -3417-. |
| q | Specified torque: 20 Nm |
| 11 - | Oil sump |
| q | Removing and installing → Chapter |
| q | Clean sealing surface before fitting. |
| q | Install with silicone sealant D 176,501 A1 → Chapter |
| 12 - | 8 Nm + turn 90° further |
| q | Renew. |
| 13 - | Suction line |
| q | With integrated seal. |
| 14 - | 8 Nm |
| 15 - | Seal |
| q | Renew if damaged. |
| q | Removing and installing → Chapter |
| 16 - | 20 Nm |
| 17 - | Oil drain plug, 30 Nm |
| q | With attached seal. |
| q | Renew. |
| 18 - | Oil pump |
| q | Renew complete only. |
| q | Removing and installing → Chapter |
| 19 - | 8 Nm + turn 90° further |
| q | Renew. |
| 20 - | Gasket |
| q | Renew. |
