Up!
| Assembly overview - lower suspension link, swivel joint |
Note| t | It is not permitted to carry out welding and straightening operations on load-bearing or wheel-guiding suspension components. |
| t | Always renew self-locking nuts. |
| t | Always renew corroded nuts and bolts. |
| t | Bonded rubber bushes can be twisted only to a limited extent. Therefore, tighten the bolted connections of components with bonded rubber bushes only when the wheel bearing housing has been raised (unladen position) → Chapter. |
| 1 - | Front bonded rubber bush |
| q | Removing and installing → Chapter. |
| 2 - | Lower suspension link |
| q | If damaged, also renew swivel joint. |
| q | Removing and installing → Chapter. |
| 3 - | Rear bonded rubber bush |
| q | Removing and installing → Chapter. |
| 4 - | Wheel bearing housing |
| q | Removing and installing → Chapter. |
| q | If wheel bearing housing is renewed, wheels must be aligned → Chapter |
| q | Various versions |
| q | Allocation → Electronic parts catalogue „ETKA“ |
| 5 - | Nut |
| q | 60 Nm |
| 6 - | Swivel joint |
| q | Checking → Chapter |
| q | Removing and installing → Chapter. |
| q | Renew together with suspension link if suspension link is damaged |
| 7 - | Nut |
| q | 100 Nm |
