volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing headlight range control regulator > < Lights and controls in the dash panel

Up!

Removing and installing light switch
Removing and installing light switch
The following components are integrated into the light switch -E1-, depending on the vehicle's equipment level:
t  Front and rear fog light switch -E23-
t  Light switch illumination bulb -L9-
Removing:
–  Switch off ignition and all electrical loads, and then pull out ignition key.
   
–  Turn rotary knob of the light switch -E1- to the „0“ position.
–  Push rotary knob of light switch -E1- in -1- and turn clockwise a little -2-.
–  Hold rotary knob in this position and pull light switch -E1- out of dash panel -3- by the rotary knob, taking connected wire lengths into consideration.
–  Release connector and pull it off.
Installing:
  N96-11017
–  Attach connector so that it latches into place.
–  Hold light switch and press rotary knob of light switch -E1- firmly into dash panel -1- and then turn knob clockwise a little -2-.
–  Hold rotary grip in this position and insert light switch -E1- into dash panel -3- using rotary grip.
–  Turn grip of light switch to position „0“, release and engage light switch -E1-.
  N96-0218

Removing and installing headlight range control regulator > < Lights and controls in the dash panel