volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing start-stop mode switch > < Removing and installing headlight range control regulator

Up!

Removing and installing switch module in middle of dash panel
Removing and installing switch module in middle of dash panel
Depending on the equipment in the vehicle, the following pushbuttons and lights are built into 2 switch modules on the left and right of the heating/air-conditioning controls. The procedure for removal and installation is identical for both switch modules and is therefore described for one switch module only. The removed switch modules cannot be dismantled further.
t  Warning lamp button -E229-
t  Indicator lamp for front passenger side airbag is off -K145-
t  Button for heated rear window -E230-
t  Button for seat heater on right -E654-
t  Button for seat heater on left -E653-
t  Button for start/stop mode -E693-
Special tools and workshop equipment required
   
t  Removal wedge -VAS 3409-
  Note
t  When removing and installing components that are in view (switches, covers, trim and so on), mask off areas in which tools (removal wedge -VAS 3409-, screwdriver) are used to lever out those components using commercially available masking tape.
t  The procedure for removal and installation is identical for both switch modules and is therefore described for one switch module only.
Removing:
–  Switch off ignition and all electrical loads, and then pull out ignition key.
–  Remove dash panel trim in the middle → General body repairs, interior; Rep. gr.68.
  W00-0016
–  Prise out the switch module in the middle of the dash panel, using the removal wedge -VAS 3409- to release the catches -arrows-.
–  Release and pull off connector and then remove switch module.
Installing:
Installation is carried out in reverse order of removal.
  N96-11018

Removing and installing start-stop mode switch > < Removing and installing headlight range control regulator