volkswagen Workshop Repair Guides

Volkswagen Workshop Manuals

< PREV PAGE NEXT PAGE >
Removing and installing front interior and reading light in vehicles with panoramic sunroof
Removing and installing front interior and reading light in vehicles with panoramic sunroof
The front interior and reading light contains the following components:
t  Front interior light -W1-
t  Front passenger reading light -W13-
t  Driver side reading light -W19-
t  Sliding sunroof adjustment regulator -EX4- → Chapter
Special tools and workshop equipment required
   
t  Removal wedge -VAS 3409-
  Note
When removing and installing components that are in view (switches, covers, trim and so on), mask off areas in which tools (removal wedge -VAS 3409-, screwdriver) are used to lever out those components using commercially available masking tape.
Removing:
–  Switch off ignition and all electrical loads, and pull out ignition key.
  W00-0016
–  Carefully lever out the lens -1- of the front interior and reading light with the removal wedge -VAS 3409- applied to the catches -arrows-.
  N96-11013
–  Release the locking lugs by pushing them in -direction of arrows- and remove front interior and reading light -1- from roof trim, taking connected wiring lengths into consideration.
  N96-11014
–  Release and detach connectors -1- and -2- and then remove front interior and reading light.
Installing:
Installation is carried out in reverse order of removal.
  N96-11012

Vehicle electrics > Electrical system > Lights, lamps, switches inside, anti-theft system > Lights and controls in the roof trim > Removing and installing front interior light and reading light > Removing and installing front interior and reading light in vehicles with panoramic sunroof

< PREV PAGE NEXT PAGE >