volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing fog light bulb > < Assembly overview - fog lights

Up!

Removing and installing fog light
Removing and installing fog light
  Note
t  The illustrations show removal and installation of the front left fog light.
t  Removal and installation of the right headlight are carried out analogously.
Removing:
–  Switch off ignition and all electrical loads, and pull out ignition key.
–  Detach front area of liner in front wheel housing to gain access to back of fog light → General body repairs, exterior; Rep. gr.66.
   
–  Release connector -1- and pull off.
  Note
When the fog light is being removed, it may be necessary to push the flexible filling pipe of the washer fluid reservoir to one side a little in order to gain access to all the securing screws.
–  Undo screws -arrows- and remove fog light housing -2- from front bumper cover -3-.
Installing:
Installation is carried out in the reverse order. When installing observe the following:
–  Tighten all threaded connections to torque specified in assembly overview → Chapter.
–  Check functioning of fog light.
–  Check fog light settings and adjust if necessary: → Booklet.
  N94-12625

Removing and installing fog light bulb > < Assembly overview - fog lights