Volkswagen Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Coding the parking aid control unit >
< Removing and installing rear parking aid senders
Up!
Vehicle electrics
Electrical system
Lights, lamps, switches outside
Parking aid
Removing and installing parking aid control unit
Removing and installing parking aid control unit
Removing and installing parking aid control unit
The parking aid control unit -J446- is located under the left side panel trim in the luggage compartment.
Removing:
–
Switch off ignition and all electrical loads, and pull out ignition key.
–
Remove left-hand side panel trim in luggage compartment
→ General body repairs, interior; Rep. gr.70
.
–
Release and pull off connector
-2-
.
–
Undo the two nuts
-arrows-
and remove parking aid control unit -J446-
-1-
.
Installing:
Install in the reverse order of removal. When doing this, note the following:
–
Tighten the two nuts to torque specified in assembly overview
→ Chapter
.
Vehicle electrics
Electrical system
Lights, lamps, switches outside
Parking aid
Removing and installing parking aid control unit
Coding the parking aid control unit >
< Removing and installing rear parking aid senders