volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing windscreen washer pump > < Assembly overview - windscreen washer system

Up!

Removing and installing washer fluid reservoir
Removing and installing washer fluid reservoir
Removing:
–  Switch off ignition and all electrical loads, and pull out ignition key.
–  Remove front bumper cover → General body repairs, exterior; Rep. gr.63.
   
–  Press locking mechanism -arrow- and pull filler neck -1- upwards out of mounting on lock carrier.
  N92-10616
–  Pull windscreen and rear window washer pump -V59--2- together with connected lines upwards out of reservoir -5-.
–  Collect any escaping washer fluid in a suitable container.
  N92-10618
–  Release connecting pipe clip together with filler neck -2- from body.
–  Undo and remove securing bolt -5- and pull reservoir -4- out of guide -3- in -direction of arrow- towards the rear.
–  Remove reservoir -4- together with connecting pipe and filler neck -1- from vehicle.
Installing:
Install in the reverse order of removal. When doing this, note the following:
  N92-10617
–  Guide connecting pipe clip together with filler neck -1- upwards through body.
–  Push reservoir -4- onto guide -3- and secure with bolt -5-.
–  Secure connecting pipe together with filler neck -1- in body -2- and push filler neck into mounting on lock carrier until filler neck audibly engages.
–  Tighten all threaded connections to torque specified in assembly overview → Chapter.
  N92-10617

Removing and installing windscreen washer pump > < Assembly overview - windscreen washer system