| –
| Tie back any excess in the uniform probe length (approx. 50 - 250 mm) to the size of the defective probe and secure with cable ties -1-. |
| –
| Check that the connector housing of the Lambda probe is compatible with the onboard supply side. |
| –
| If necessary, replace the onboard supply system connector with the Lambda probe connector housing supplied → Chapter |
Note | t
| The connector housing should only be replaced on older vehicles. On new vehicles, the connector housing coding matches. |
| t
| Observe pin assignment. For reasons of clarity, respective pins in new connector housing have a colour marking. |
| t
| Further notes can be found in the leaflet of the new lambda probe. |
| –
| Install the new Lambda probe in the vehicle. |
|
|
|
