Vanagon F4-1915cc 1.9L (Water Cooled) (1983)
Radiator Cooling Fan Motor: Service and Repair
CAUTION: Part numbers are listed for reference only. Always consult with the Parts Department for latest information.
Snap-lock Connectors, Installing
Starting Jan.1986, the electrical connection on replacement radiator cooling fan motors is now a snap-lock connector.
When replacing a fan motor also replace the connector on the wiring harness.
This snap-lock connector was introduced on Vanagon as a running change during Jan.1986 production.
NOTE: This work procedure will be applicable when all existing stocks of replacement radiator cooling fan motors with a push-on connector are
exhausted.
Three Wire Harness
Parts Required
Work sequence:
-
disconnect battery ground strap
-
cut off old connector from wiring harness
-
push wires through rubber boot
-
attach terminal to wire
-
insert wires into connector (cavity numbers on connector)
Red/Black to cavity 3
Red/White to cavity 2
Brown to cavity 1
-
attach connector to fan motor
-
attach rubber boot
-
reconnect battery ground strap
-
check fan for proper operation
Two Wire Harness
Parts Required
Work sequence:
-
disconnect battery ground strap