Vanagon L4-1588cc 1.6L DSL SOHC (1983)
Water In Fuel Indicator: Technical Service Bulletins
Fuel Filter - Installing Water Indicator Kit
Applies To
VANAGON DIESEL
Group
23
Subject:
Fuel Filter
Part Identifier 2034
Key Points
Installing water indicator Kit C
Number
83-10
August 4, 1983
Water level indicator light will light when it is necessary to drain water from trap in fuel filter
Parts required
Qty Description
Part No...
1
water level indicator kit
175 998 030
1
"double" (single female into
double male) electrical connector
local supply
1
"ring type" electrical connector
local supply
1
grommet
171 971 913
blue 18 ga. electrical wire
local supply
Installation procedure
-
disconnect battery ground cable
-
drop down Fuse/Relay Panel
-
remove trim cover from front of floor duct
Mount control unit as follows:
-
mount retaining clip (included in Kit) to fresh air tube with sheet metal screw (included in Kit) so control unit will clip into position shown in
photo
-
also attach brown ground wire (included in Kit) under mounting screw with "ring type" connector
-
install double connector on terminal 15 of control unit and clip unit in place
-
connect ground wire from mounting screw to terminal 31 of control unit
Install and connect indicator light as follows:
-
mark and drill a 9 mm hole approx. 50 mm to right of cold start cable and mount indicator light
-
connect white wire (included in Kit) to light
-
route wire to control unit and attach to one male terminal of double connector on terminal 15
-
connect yellow wire (included in Kit) to light