Vanagon L4-1588cc 1.6L DSL SOHC (1983)
-
If no turning torque can be measured, check for rock at end of pinion. There must not be any detectable movement
-
If YES, replace tapered roller bearing
-
Press synchronizer rings onto gear by hand and measure gap (a) with feeler gauge
^
Gap a = New 1.0-1.7 mm (0.039-0.067 in)
Wear limit 0.5 mm (0.020 in)
-
Assemble 1st/2nd gear synchronizer
NOTE:
-
Gear teeth on sleeve and long collar on hub must face 1st gear when installing
-
Sleeve and hub are not matched and can be replaced separately