Vanagon L4-1588cc 1.6L DSL SOHC (1983)
-
Slide sleeve over synchronizer hub. Matched position is not necessary
-
Insert keys and install springs with ends offset 120°. Angled ends of springs must fit into keys
-
Turn synchronizer ring until grooves are in line with keys
-
Identification groove on sleeve faces 4th gear (arrow)
-
Slide sleeve over shaft and turn knurled screw in until groove (arrow) is exposed. If necessary, use M6 x 60 bolt instead of knurled screw
-
Push circlip on until it snaps into groove
