Vanagon Syncro AWD F4-2109cc 2.1L (MV) (1989)
/Page-909002.png)
- push back protective sleeve and drive out roll pin
- with bolt B withdrawn as far as possible, give servo a slight upward twist and remove from bracket
- remove circlip 1
- remove bolts (arrows)
- remove bracket
Starter motor, removing
- disconnect wires from solenoid terminals 30 and 50
- loosen lower mounting nut on starter motor (arrow)
- push up slightly on starter motor and remove
Starter, installing
- clean mating surfaces and apply sealer AMV 188 000 02 before installing starter
- installation procedure is reverse of removal
Starter motor mounting bolts torque:
